Anti-Calc System; Auto Shut-Off - Zelmer ZIR3285 Benutzerhandbuch

PL EN
All manuals and user guides at all-guides.com
10. Repeat the steps 8 and 9 three times until the tank is empty.
11. Then plug the iron in and heat it up again until the remaining water has evaporated.
12. Push the "clean" button a few times more to clean the valve.
13. Unplug the iron and let the soleplate cool down.
14. Move the iron over an old (preferably) piece of cloth. This ensures that the soleplate will be dry during
storage.
It is recommended to do the self-cleaning at least every two weeks.
Please note:
Do not use chemical additives, scented substances or decalcifies. Failure to comply with the above-
mentioned regulations leads to the loss of guarantee.

Anti-calc system

A special resin filter inside the water reservoir softens the water and prevents scale build-up in the plate.
The resin filter is permanent and does not need replacing. The "anti-calc" cartridge has been designed to
reduce the build-up of scale produced during steam ironing, helping to extend the useful life of your iron.
Nevertheless, the "anti-calc" cartridge cannot remove all of the scale that is produced naturally over time.
Please note:
Do not use chemical additives, scented substances or decalcifies. Failure to comply with the above-
mentioned regulation leads to the loss of guarantee.

Auto shut-off

This steam iron is fitted with an automatic switch-off system. This stops the iron from heating up, if the
iron is resisting on its sole and is not moved for about 30 seconds, there will be a warning beep and the
control lamp for the automatic switch-off temperature / automatic switch-off control lamp flashes. The
iron will stop heating up. To deactivate the automatic switch-off, lift up the iron and move it gently from
side to side. The control lamps for the automatic switch-off temperature / automatic switch-off control
lamp goes out and the iron will head up again.
If the iron is resisting on its base and is not moved for about 8 seconds, there will be a warning beep and
the control lamp for the automatic switch-off lamps will flash. The iron will stop heating up. To deactivate
the automatic switch-off, lift up the iron and move it gently from side to side. The control lamps for the
automatic switch-off goes out and the iron will heat up again.
14