Anti-Calc System; Anti-Drip System; Auto Shut-Off - Zelmer Stiro ZIR3000 Benutzerhandbuch

AF-MANUAL_Plancha-ZELMER ZIR3000 stiro.pdf
iron over an old (preferably) piece of cloth. This ensures that the soleplate will be dry during sto- rage.

ANTI-CALC SYSTEM

A special resin filter inside the water reservoir softens the water and prevents scale build-up in the plate.
The resin filter is permanent and does not need replacing.
PLEASE NOTE: Do not use chemical additives, scented substances or decalcifies. Failure to comply with
the above-mentioned regulations leads to the loss of guarantee.

ANTI-DRIP SYSTEM

With the anti-drip system, you can perfectly iron even the most delicate fabrics.
Always iron these fabrics at low temperatures. The plate may cool down to the point where no more steam
comes out, but rather drops of boiling water that can leave marks or stains. In these cases, the Anti-drip
system automatically activates to prevent vaporization, so that you can iron the most delicate fabrics
without risk of spoiling or staining them.

AUTO SHUT-OFF

An electronic safety device will automatically switch the heating element off if the iron has not
C
been moved more than 30 seconds in a horizontal position. If in a vertical position, this will happen after 8
minutes. To indicate that the heating element has been switched off, the auto-off pilot light will start
M
blinking.
Y
When picking up the iron again, the auto-off pilot light will turn off. The power pilot light will turn on. This
CM
indicates that the iron is heating up again.
Wait for the power pilot light to turn off. Then the iron is ready for use.
MY
CY
CMY
K
13 12/4/21 11:38
EN
13