Functional Description - Makita PV7000C Betriebsanleitung

FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the tool is
switched off and unplugged before adjusting or
checking function on the tool.
Switch action
CAUTION:
Before plugging in the tool, always
check to see that the switch trigger actuates
properly and returns to the "OFF" position when
released.
CAUTION:
Make sure to switch off the tool in
case of a blackout or accidental shut down such
as unplugging of the power cord. Otherwise the
tool will start unexpectedly when the power supply
is recovered and cause an accident or personal injury.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock-on button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
CAUTION:
Switch can be locked in "ON" posi-
tion for ease of operator comfort during extended
use. Apply caution when locking tool in "ON"
position and maintain firm grasp on tool.
► Fig.1: 1. Lock-on button 2. Switch trigger
Speed adjusting dial
The rotation speed of the tool can be changed by turn-
ing the speed adjusting dial. The table below shows
the number on the dial and the corresponding rotation
speed.
► Fig.2: 1. Speed adjusting dial
Number
1
2
3
4
5
NOTICE:
If the tool is operated continuously at
low speed for a long time, the motor will get over-
loaded, resulting in tool malfunction.
NOTICE:
The speed adjusting dial can be turned
only as far as 5 and back to 1. Do not force it past
5 or 1, or the speed adjusting function may no
longer work.
Constant speed control
Possible to get fine finish, because the rotating speed is
kept constantly even under the loaded condition.
Speed
-1
600 min
-1
800 min
-1
1,300 min
-1
1,800 min
-1
2,100 min
Soft start feature
Soft start feature reduces starting reaction.
High-Low speed setting button
The tool speed can be changed instantly while the tool
is running.
Depress the "I" position for lowest speed, and depress
"II" position for a given number setting.
The tool speed cannot be changed when the button is in
"I" position, even if you turn the speed adjusting dial.
When you turn the speed adjusting dial, always be sure
that the button is depressed in "II" position.
► Fig.3: 1. High-Low speed setting button
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and unplugged before carrying out
any work on the tool.
Installing side grip (handle) and
cover
CAUTION:
Always be sure that the side grip is
installed securely before operation.
Install the cover, then screw the side grip on the tool
securely.
The side grip and the cover can be installed on either
side of the tool.
► Fig.4: 1. Cover 2. Side grip
► Fig.5: 1. Cover 2. Side grip
Installing or removing backing pad
Optional accessory
Hold the spindle with the wrench so that the spindle
cannot revolve.
Then screw the backing pad onto the spindle all the
way. (The backing pad can be used to install the
optional sponge pad.)
► Fig.6: 1. Backing pad 2. Spindle 3. Wrench
To remove the backing pad, follow the installation pro-
cedure in reverse.
Installing or removing sponge pad
Optional accessory
► Fig.7: 1. Sponge pad 2. Backing pad
1.
To install the sponge pad, remove all dirt or foreign
matter from the backing pad.
2. Install the sponge pad to the backing pad.
To remove the sponge pad, pull it off from the backing
pad slowly.
7 ENGLISH