Network Setup; System-Setup - HifiPilot Surround Hub Bedienungsanleitung

Network Setup

● Network Select: Here you can choose how the Surround Hub should connect
to the network:
○ Automatic: The connection is made automatically.
○ Wi-Fi: The connection is made via WiFi.
○ Ethernet: The connection is made via Ethernet.
● IP address: Here you can see the IP address assigned to the device by the
router.
● Module Status: Here you can see the status of the network module.
● Reset Stream Module: Here you can reset the network module.
Wisa Setup
● Wisa Pair: Here you can start the Surround Hub's pairing mode.
● Wisa Unpair: Here you can end the connection to speakers.
● Wisa Reset: Here you can reset the WiSA module.
System Setup
● Automatic standby: Here you can configure the automatic standby:
○ 20 min.: The Surround Hub switches to standby mode after 20 minutes
without an input signal.
○ 60 min: The Surround Hub will go into standby mode after 60 minutes
without an input signal.
○ OFF: The Surround Hub does not go into standby mode automatically.
● HDMI CEC: Here you can activate or deactivate the HDMI CEC function.
● System Reset: Here you can reset the Surround Hub to the factory settings.
● Firmware Info: Here you can see the current software version of the
Surround Hub.
18