Menu Options; Source Setup; Speaker Setup - HifiPilot Surround Hub Bedienungsanleitung

Source Setup

● Source: Here you select the source that you want to configure.
● Audio In: Here you can select for the HDMI inputs whether the sound of the
respective HDMI signal or the sound of the cinch input should be output.
● Lip Sync: Here you can delay the image signal compared to the audio signal
in order to receive image and audio simultaneously.
● Level: Here you can adjust the volume of the source individually.
Surround Upmixing
Here you can set the desired sound mode. The note icon indicates which mode is
currently selected. The following modes are available:
● Auto Select: The input signal is passed on to the corresponding
loudspeakers unchanged.
● Stereo: The input signal is converted to stereo and sent to the appropriate
speakers.
● Dolby Surround: The input signal is converted to Dolby Surround and sent to
the appropriate speakers.
● DTS Neural X: The input signal is converted to DTS Neural X and sent to the
appropriate speakers.

Speaker Setup

● Speaker layout: Here you can set the existing speaker setup and assign the
speakers to the desired channel.
● Crossover Setup: Here you can set the desired crossover frequency for each
channel type:
○ Full Range: The loudspeakers receive the complete signal and are not
cut off.
○ XX Hz: The speakers are cut off below the selected frequency. The
subwoofer will cut off above the selected frequency.
● Distance Setup: Here you can set the distance of the speakers from the
listening position in increments of 10 cm.
● Level Adjustment: Here you can adjust the volume of the individual channels
individually.

Menu options

17