Landing; Maintenance; Troubleshooting; Corrective Action - XciteRC Rocket 55XXS 3D Bedienungsanleitung

Landing:

• Carefully push the left throttle lever rearward. Try to land „smooth" without damaging the Quadrocopter.
EN • NOTE: if the flight battery runs empty, the Quadrocopter does not respond accurately to your com-
mands, the flight is unstable. In this case land immediately.
• Switch of the Quadrocopter and then the transmitter.

Maintenance

To have fun with your model over a long period, occasional service work is required to get your model in good
condition and to minimize wear.
• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a
harder brush or a toothbrush can be used.
• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic
of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up
liquid.
• Check the tightness of all screws and tighten if necessary.
• Also check all connections, cables and power battery / rechargeable battery for damage.
• WARNING: Damaged batteries or rechargeable batteries must not be used again and must be
disposed of immediately – fire hazard! Please note the disposal notes at the end of this manual.
• Check the model for worn, broken or jammed parts and gears and repair if necessary.
• WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fire hazard!

Troubleshooting

Problem
Rotor don't move
Rotor stops sud-
denly, Quadrocop-
ter chrashes
The Quadrocopter
does not react to
the remote control.
Loss of control.
22
Possible Cause
ON/OFF switch is OFF
Weak Quadrocopter battery
Transmitter - model not bound
Weak Quadrocopter battery
Weak transmitter battery
Gyro initialisation failure
Another radio controlled device using
the same channel
Transmitter - model not bound
Landing · Maintenance · Troubleshooting

Corrective Action

Switch ON Quadrocopter
Re-charge battery
Rebind: see chapter Getting started
Re-charge battery
Change transmitter batteries
Place the model on a flat surface when
switching on
Switch off another/own device or move to
another spot
Rebind: see chapter Getting started
XciteRC Rocket 55XXS