Abbildung 244. Wasserkreislaufhalterung entfernen
9. Install the water loop screws (13x Torx T10 screws per node) with a torque screwdriver sets to the
proper torque.
Anmerkungen:
• Das Drehmoment zum vollständigen Anziehen/Lösen der Schrauben beträgt 0,5-0,6 Newtonmeter
bzw. 4,5-5,5 Poundforce Inch.
• The screw holes that are circled in blue are meant for 9.5 mm screws, while the others that are circled
in red are meant for 8.0 mm ones.
266
ThinkSystem SD650 V2/SD650-N V2 Neptune DWC Einbaurahmen und DW612 Neptune DWC GehäuseWartungshandbuch