About This User Information; Safety; Intended Use; Foreseeable Misuse - hymer Backrack+ Mini Rack Sicherheits- Und Montageanleitung

ABOUT THIS USER INFORMATION

This user information is intended for the responsible
vehicle driver/owner. Read the user information carefully
before installing and using the product.
Keep this user information in the vehicle and pass it on
X
when the owner changes.
When installing and using the product, observe all
X
the vehicle manufacturer's instructions (see vehicle
manual).
We reserve the right to make changes with regard to de-
sign, equipment and colour. Illustrations are non-binding.

SAFETY

Intended use

The Backrack+ Mini Rack is designed to be installed on
the Backrack+ base frame and is used exclusively for
transporting additional luggage up to 20 kg.
Any other use is considered improper. The Backrack+
Mini Rack is referred to in the following as the rear carrier
system/accessories.
Only install the rear carrier system/accessories in accor-
X
dance with the installation instructions.
Only install the rear carrier system/accessories to vehi-
X
cles with a properly installed Backrack+.
Only use original accessories and original spare parts.
X
Check with the respective manufacturer regarding the
suitability of any other accessories.
The driver of the vehicle is responsible for the rear
X
carrier system/accessories and for compliance with the
relevant regulations.
In the event of improper installation, use or use that
deviates from the user information or use that is not in
accordance with the intended purpose, all guarantee and
warranty claims against the manufacturer will be voided.

Foreseeable misuse

• The rear carrier system/accessories are not designed for
installation by children or youth.
• If conversions and modifications are made to the rear
carrier system/accessories, the type approval is voided.
• Installation without Backrack+ is not permitted.
• The additional luggage must be packed securely and
properly fastened. The user is responsible for the fas-
tening.
• A folded down rear carrier system/accessories must
also be secured.
• Fold up and secure an unloaded rear carrier system/
accessories while driving (see diagram 19).
• The maximum load of 20 kg must not be exceeded.
• If the door is swung open fully, the load can damage
the shell of the vehicle.
• On a slope, be careful when opening/closing the rear
doors with a load.
• Driving into car washes with the mounted components
installed is not permitted.

General safety instructions

Only transport the load secured and with the rear carri-
X
er system/accessories folded down.
When using the rear carrier system/accessories, ensure
X
that the national laws of the respective country are
complied with.
Ensure that the change in the axle load distribution due
X
to the rear carrier system/accessories does not lead to
the permissible axle loads being exceeded.
Replace damaged parts immediately with original
X
spare parts. Do not use a damaged rear carrier system/
damaged accessories for transporting bicycles.
When using sliding blocks, make sure that the groove
X
channel is not damaged or deformed.
Only use sliding blocks in the areas intended for the
X
approved mounted components.
Only use original accessory sliding blocks.
X

Safety instructions for lighting

If vehicle lights or number plates are obscured (even
X
partially) by the rear carrier system/accessories or the
load, duplicate them.
Before initial use, ensure that all lights and number
X
plates are visible and fully functional.

Safety instructions for the load

Do not exceed a load of 20 kg.
X
When loading, make sure the load is distributed and
X
the centre of gravity is as low as possible. Secure the
load against slipping and check regularly that it is in the
correct position.
When loading, make sure that no vehicle components
X
are covered (e.g. windscreen wipers, spoiler, exhaust).
Backrack+ Backrack+
EN
7 7