Setting Up Home Connect; Home Connect Settings - Siemens CT7 Serie Gebrauchsanleitung

en Home Connect
The Home Connect services are not
available in every country. The avail-
ability of the Home Connect function
depends on the availability of
Home Connect services in your coun-
try. You can find information about
this at: www.home-connect.com.
The Home Connect app guides you
through the entire login process. Fol-
low the instructions in the Home Con-
nect app to configure the settings.
Tip: Please also follow the instruc-
tions in the Home Connect app.
Notes
¡ Please note the safety precautions
in this instruction manual and
make sure that they are also ob-
served when operating the appli-
ance via the Home Connect app.
→ "Safety", Page 41
¡ Operating the appliance on the ap-
pliance itself always takes priority.
During this time it is not possible
to operate the appliance using the
Home Connect app.
Overview of the Home Connect settings
Here you can find an overview of the "Home Connect" settings and network set-
tings.
Basic setting
Home Connect
assistant
WiFi
54
Selection
Start
Disconnect
On
Off
13.1 Setting up Home Con-
nect
Requirements
¡ The appliance is already connec-
ted to the mains power supply and
switched on.
¡ You have a mobile device with a
current version of the iOS or An-
droid operating system, e.g. a
smartphone.
¡ The mobile device and the appli-
ance are within range of your
home network's WiFi signal.
¡ The Home Connect app has been
installed on your mobile device.
Open the Home Connect app and
1.
scan the following QR code.
→ Fig. 26
Follow the instructions in the
2.
Home Connect app.
13.2 Home Connect settings
Adapt Home Connect to your needs.
You can find the Home Connect set-
tings in the basic settings for your ap-
pliance. Which settings the display
shows will depend on whether
Home Connect has been set up and
whether the appliance is connected
to your home network.
Description
Add mobile device.
Disconnect appliance from network.
Switch off the wireless module during
long absences or to save energy.
Note: In networked standby mode
your appliance requires max. 2 W.