Assembling The Interfaces In The Control Panel - Elkron MP3040 Installations-Kurzanleitung

8
CPU BOARD DESCRIPTION
CPU BOARD LAYOUT KEY
OPER GREEN LED
COM GREEN LED
A
+3V3 RED LED
CLOUD GREEN LED
RUN RED LED
B PWR RED LED
DIP switch ON = Maintenance in progress
SW2-1
DIP switch OFF = Normal operation
DIP switch ON = Reset codes
SW2-2
DIP switch OFF = Normal operation
C
DIP switch ON = Total reset
SW2-3
DIP switch OFF = Normal operation
DIP switch ON = Not allowed
SW2-4
DIP switch OFF = Normal operation
D
RES Reset button if pressed for 5 sec
E EXC Jumper inserted = Tamper bypassed
F TAMPER Tamper connector
+BAT
Back-up battery connection cable
G
12 V⎓ 7Ah
-BAT
+PS Board power positive (14,4 V⎓)
H
-PS Board power negative (GND)
USB connector type B. For local connection of a
I
USB-B
PC for programming
RJ45 connector. For connecting the control unit
J LAN
to a LAN or modem/router
K OPTO 1 Connector for optional interface
L OPTO 2 Connector for optional interface
M OPTO 3 Connector for optional interface
* For connection of the ER3000-RF wireless expansion
EN50131
EN 50131 grade 2 certified device
GRADO 2
3.

ASSEMBLING THE INTERFACES IN THE CONTROL PANEL

Assemble the required interface boards on the CPU board. Up to three interfaces, not more than one
per type, can be installed:
• IT3000-PSTN, telephone line interface (max 1, preferably on OPT1);
• IT3000-2G, GSM interface, or IT3000-4G, 4G interface (max 1, preferably on OPT2);
• ER3000-WIFI (max 1) and ER3000-ZB (max 1, preferably on OPT3).
IMPORTANT!
The interfaces must be inserted and removed with the control panel not powered (mains and battery
disconnected).
On = Normal operation
Flashing = System start
Flashing = Normal operation
Logic present power (+3,3 V⎓)
On = Cloud connected
Flashing = Normal operation
Board power supply present
(14,4 V⎓)
N BUS RED LED
+ Power positive (13,8 V⎓)
O* A / B BUS Data transmission/reception A / B
- Power negative (GND)
+ Power positive (13,8 V⎓)
P A / B BUS Data transmission/reception A / B
- Power negative (GND)
SR Power output without back-up (14,4 V⎓)
+V1 Power output positive (13,8 V⎓)
-V1 Output power negative (GND)
Q NC1 Output 1 - relay, contact normally closed
NO1 Output 1 - relay, normally open contact
C1 Output 1 - relay, common contact
U2 Output 2 - electric
SAB SAB input - single-balanced
+V2 PrIO power positive (13,8 V⎓)
-V2 PrIO power negative (GND)
IN1 Input 1, referred to positive
R
IN2 Input 2, referred to positive
IN3 Input 3, referred to positive
IN4 Input 4, referred to positive
IN5 Input 5, referred to positive
IN6 Input 6, referred to positive
+V2 Power positive (13,8 V⎓)
-V2 Power negative (GND)
S
P7 PrIO 7 – programmable input/output
P8 PrIO 8 – programmable input/output
Flashing = Bus communication
10