Inhaltsverzeichnis
Werbung
TECHNICAL FEATURES
Nominal power voltage
Nominal output voltage
Rated current consumption at 230 V
PS515
Max. current that can be delivered
power unit
Max. ripple
Fuse
Insulation class
(1) If the battery is not connected, there is no voltage at the ends of the connecting cables (red and
black Faston).
(2) +SR does not supply voltage in the event of a mains power failure.
(3) A line fault must be recognised within 20 seconds (SP6) to ensure compliance with EN50136-2 in
the LAN configuration.
DP1 guaranteed with:
DP2 guaranteed with:
2. INSTALLATION
1
BOX OPENING
2
SCORED OPENINGS FOR CABLE ROUTING
3
CPU CARD REMOVAL/INSERTION
4
FIXING TO THE WALL
Assemble only on the wall at a height of ≤ 2 mt. Use at least 4 wall plugs with a diameter of
6 mm of a type suited to the characteristics of the wall (not supplied).
A - Fixing hole for removal protection
5
CONTROL PANEL TAMPER CONNECTION
6
POWER SUPPLY FIXING
A - Cables included
B - Short cable tie included for compulsory cable fixing 230 V~
7
BATTERY CONNECTION AND FIXING
A - Long cable tie supplied for battery fixing.
The cable ties passes through the holes for routing the cables.
IMPORTANT
Disconnect the mains power supply before making connections to the mains.
Once installed, the power supply is subject to transient voltages higher than those of the overvoltage
category for which it was designed. For this reason, an additional transient voltage protection is required
outside the device. Wires with cross-section area of 0.5 mm² or larger must comply with IEC 60332-1-2;
wires with cross-section area smaller than 0.5 mm² must comply with IEC 60332-2-2.
9
Primary LAN and alternate IT3000 interface.
Primary LAN and alternative IT3000-2G interface, with periodic test not
exceeding 30 min. enabled.
220-240 V~ +10% -15% 50/60 Hz
14,4 V⎓
0,6 A
1,5 A
100 mVpp con I=1A
T2AL 250 V~
II
Werbung
Inhaltsverzeichnis
