Parkside PTBS 30 A1 Bedienungsanleitung Seite 8

Connection principle of the
distributor tubes q/w
All parts of the product that you
can connect to the distributor tubes
q/w follow the same principle.
♦ Unscrew the union nut anti-
clockwise.
♦ Push the union nut with the
narrow side onto a distributor
tube q/w.
Push the distributor tube q/w
♦
onto the bracket.
♦ Screw the union nut clockwise
onto the thread of the bracket.
PTBS 30 A1
Assembly
NOTE
► Spread out the distributor
tubes q/w and leave them
in the sun for one to two
hours to make them easier to
straighten.
► Use sharp all-purpose scissors
to cut the distributor tubes
q/w. Straighten and deburr
the cut with a cutter if neces-
sary.
Use the long hose holders 0
►
for the wide distributor tubes
w and the short hose holders
9 for the narrow distributor
tubes q.
♦ Lay out the wide distributor
tube w and cut it into the re-
quired lengths. Cut the ends of
all distributor tubes w straight.
♦ Connect the required L- and
T-connectors 2/3 with the
cut-to-size distribution pipes w.
GB │ IE │
5 ■