Thrustmaster T818 Firmware-Aktualisierung Seite 6

6) Turn on your racing wheel in Boot mode.
- Turn off your racing wheel by pressing the switch button to put it in the OFF
position.
- Simultaneously press buttons 22 and 23 (located on the right side of the servo
base) then turn on the racing wheel by moving the switch button to the ON
position (while holding down buttons 22 and 23).
Buttons 22 and 23:
- Once the servo base is on, release buttons 22 and 23.
Note:
- After releasing buttons 22 and 23, the racing wheel goes into Boot mode, so a
"Bulk" driver, necessary for updating the device, is automatically installed on
your PC. It may therefore be necessary to wait a few moments before
proceeding.
- During this operation, the racing wheel do not auto-calibrate (automatic
movements of the wheel from left to right) when connecting: this is normal.
- The racing wheel's LED is off: this is normal.
- The racing wheel is not detected in the Control Panel: this is normal.