FITFIU FITNESS MC-180 Betriebsanleitung Seite 59

TROUBLESHOOTING
The following information may assist in identifying a problem and rectifying it.
Problem
Equipment will not A. Equipment not plugged in.
start. B. Safety tether not in place.
Belt slips. Belt loose.
A. Not enough lubrication on
Belt hesitates when
running deck.
stepped on.
B. Belt too tight.
Running belt tension not even
Belt is not centred.
across the rear roller.
Communication problem
Display shows "E01" between drive unit and console
detected.
Drive unit / motor problem
Display shows "E02"
detected.
Display shows "E05" Electrical protection tripped.
Display shows "E06" Power supply protection tripped.
Display shows "E07" Safety tether not in place.
Equipment unsteady Surface not flat.
Cause
A. Connect unit to mains electrical supply.
B. Place safety tether in correct location.
Adjust belt tension.
A. Lubricate running deck.
B. Adjust belt tension.
Adjust belt alignment.
Check connections between console and drive
unit. If the connectors or wiring is damaged,
replace it.
Check drive unit and motor connections. if the
motor is damaged, replace it.
Check mains electrical supply is to specifications.
• Ensure that drive belt is not caught or is unable to
rotate due to obstruction.
• Check all connections.
• Check for motor or control circuitry fault (often
indicated by a burning smell) and replace parts as
required.
Check mains electrical supply is to specifications.
• Check all connections.
• Check for motor or control circuitry fault (often
indicated by a burning smell) and replace parts as
required.
Place safety tether in correct location on console.
Set-up equipment on a flat surface. • If applicable,
rotate feet under front of machine to move up or down
as needed so equipment is steady.
59
MC-180
Solution
EN