Herunterladen Inhalt Inhalt Diese Seite drucken

FITFIU FITNESS MC-180 Betriebsanleitung Seite 58

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 63
CLEANING
The equipment can be cleaned with a soft cloth and mild detergent. Do not use abrasives, solvents or harsh chemicals.
Be careful not to get excessive moisture on the display panel as this may damage it and create an electrical hazard.
After each use, wipe the unit of any sweat, dirt or liquids. Pay extra attention to the edges of the belt, where it meets
the running boards on each side of the running belt – keeping this area clean will help prolong the life of the unit and
maintain its performance. Keep the equipment, especially the display console, out of direct sunlight to prevent damage
to the screen.
MAINTENANCE
BELT LUBRICATION
Lubricating the running belt helps maintain performance and extends service life. Lubricate the belt after the first 25
hours of use (or 2 to 3 months), then every 50 hours of use (or 5 to 8 months, or more frequently under extended usage).
To check if the belt requires lubrication, lift each side of it and feel the top surface of the running deck. If the deck is
slick to the touch, no lubrication is required; if it is dry, lubricate. To apply lubricant.
1.
Lift the edge of the running belt so the running
deck is exposed.
2.
Place several drops of the supplied lubricant
along the centre of the running deck.
3.
Run the equipment at a slow speed for 3 to 5
minutes to evenly distribute lubricant.
NOTE: Do not over lubricate. Wipe away any excess lubricant from the running belt.
All-purpose household oil or sewing machine oil can also be used.
BELT ALIGNMENT AND TENSION ADJUSTMENT
The running belt is pre-adjusted to the running deck at the factory, but after prolonged use it can stretch and require re-
tensioning. To adjust the belt, turn on the main power switch of the equipment and let the belt run at a speed of 6km/h.
Use the Allen key provided to turn the rear roller adjustment bolts to center the belt.
If the running belt is shifting to the left, turn the
left adjustment bolt 1/4 turn to the right, and the
running belt should start to correct itself.
If the running belt is shifting to the right, then turn
the right adjustment bolt 1/4 turn to the left, and the
belt should start to correct itself. Keep turning the
adjustment bolts until the running belt is properly
centered.
If the running belt is slipping during use, turn off and
unplug the equipment. Using the Allen key provided,
turn both left and right rear roller adjustment bolts 1/4
turn to the right, then turn the main power switch back
on and run the equipment at a speed of 6km/h. Run on
to the running belt to determine if the belt is still slipping.
Repeat this procedure until the belt no longer slips.
58

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis