Set The Canopy; Set The Plastic Shade - Sygonix 2472505 Bedienungsanleitung

When the wiring is complete, insert the receiver as
shown.

10.4 Set the canopy

When finished wiring, attach the canopy to the hanger
bracket. Push up and twist to locate the screws into the
holes, and then firmly tighten. NOTE: The screws pro-
trude for attaching the canopy cap.

10.5 Set the plastic shade

Remove 3x screws and attach the housing.
Use 3x washers as shown.
Attach the canopy cap to the canopy.
Connect the light kit as shown.
Position the plastic shade and twist it until it locks
into place.
Make sure it is securely fastened before letting go.
Connect
33