Remote (Transmitter) And Receiver Pairing; Installation; Install The Hanger Bracket - Sygonix 2472505 Bedienungsanleitung

9 Remote (transmitter) and receiver pairing

The transmistter and receiver were paired at the factory. If the connection is broken, follow these steps:
1. Switch the fan power OFF for 10 seconds.
2. Switch the fan power back ON.
A beep will sound, within 3 seconds press and hold the FAN OFF button on the remote control until you hear a
second beep, then release the button.
3. The pairing process is complete. If for some reason the pairing process failed, repeat steps 1 and 2.

10 Installation

Risk of fatal electric shock! Always switch the mains power supply off before beginning installation.
Mounting of the suspension system should be performed by the manufacturer, its service agent, or suitably
qualified persons.
Important:
– Do not overtighten screws as this can strip threads and/or
damage the product.
– The fan should be installed so that the blades are more than
2.3 m above the floor.
– Observe the minimum clearances shown. Failure to do so
can result in injury and/or damage.
– Observe: "7.8 Electrical installation" on page 26.
– Observe: "7.9 Installation" on page 26."

10.1 Install the hanger bracket

Tools needed:
–
RE
min. 0.3 m
min. 2.3 m
29