Dust Container; Replacements; Specific Operations For Endothermic Models (Csw 700 G - Csw 900 G) - Comet CSW 700 Bedienungs- Und Wartungsanleitung

EN
- Instructions and operating manual CSW 700 B/G - CSW 900 B/G (translated from original instructions)
u DUST CONTAINER:
Every 50/60 working hours or when required, wash the dust container part. A fig. 1, with hot water and
common detergent to avoid possible bacterial formations. This operation must be carried out using
strong rubber gloves.
GENERAL INFORMATION: For the correct operation and long life of the machine, keep the outside bodywork
as well as the inside of the machine clean, and blow compressed air under the casings (this operation must
be carried out with the engine off and cold).
u REPLACING THE CENTRE BRUSH:
Always wear gloves and a breathing mask when replacing the centre brush and only carry out this manoeuvre
with the engine at a standstill and cold.
1. Remove the bin Detail A Fig.1 and push the handle to bring the machine into the position illustrated
in Fig.13.
2. Unscrew and remove the two screws Detail A and B Fig. 13.
3. Before removing the brush from the machine note the direction of the bristles (see Fig.13).
4. Remove the worn brush and replace it with a new one.
5. Replace and tighten the screws Detail A and B Fig. 13 and adjust the height of the brush (see para-
graph ADJUSTMENTS: CENTRE BRUSH).
u REPLACING THE SIDE BRUSH:
1. Remove the bin Detail A Fig.1 and tilt the machine as shown in Fig.13.
2. Unscrew and remove the three screws Detail C that hold the side brush Detail 1 in place.
3. Remove the brush belt from the plastic pulley.
4. Remove the side brush using a screwdriver for leverage in the groove on the pulley race (see Fig.14)
5. Assemble a new brush and secure it by carrying out the above operations in reverse order.
u REPLACING THE DUST FILTER:
Check the dust filter Detail 4 Fig. 8 every 40 - 70 working hours or as needed. Check and take the filter from its seat
by removing the cotter pins Detail 2 Fig .8 and unscrew the handwheels Detail 1 Fig.8. Once the filter has been
replaced, proceed with the above operations in reverse order.
SPECIFIC OPERATIONS FOR ENDOTHERMIC MODELS (CSW 700 G – CSW 900 G)
CARRY OUT THE OPERATIONS FOR CHECKING THE ENGINES OR CHANGING THE WHILE WE-
ARING PROTECTIVE NITRILE GLOVES. USED OIL MUST BE DISPOSED OF ACCORDING TO THE
STANDARDS ENFORCED BY THE LAW.
It is necessary to read the specific use and maintenance hand book of the engine enclosed.
Normal maintenance involves:
1. Checking the oil lever every 5 working hours.
2. Changing the oil after the first 5 hours (follow the indications in the engine handbook for the type of oil
to use).
3. Changing the oil every following 25 hours in the case of heavy duties, or every 50 hours of normal use.
4. Cleaning the air filter every 25 hours.

REPLACEMENTS

pag. 39