Adjustments - Comet CSW 700 Bedienungs- Und Wartungsanleitung

EN
- Instructions and operating manual CSW 700 B/G - CSW 900 B/G (translated from original instructions)
u SIDE BRUSH
Detail 1 Fig. 9. Keep raised from the ground when not in use to avoid raising dust unnecessarily. Keep
raised from the ground when the machine is not in use and make sure it does not come into contact with
other objects which could bend it making it unserviceable.
u CENTRE BRUSH
Every 50 / 80 hours of work or when required, check the good condition of the central brush, part 2 Fig. 9,
the main component of the machine; in particular if you fear to have inadvertently picked up threads, cords,
etc..
To remove said material from the brush, it is necessary:
FOR ELECTRIC MACHINES, REMOVE THE BATTERIES FROM THEIR SEATS AND PLACE THEM ON
THE GROUND BEFORE DOING THIS OPERATION.
1. Remove the dust container part. A fig. 1.
2. Position the machine as shown in Fig. 9 until the handle rests on the ground.
3. Using gloves and possibly a mask to protect the respiratory tract, remove threads, cords etc. using pliers
and scissors.
u CENTRE BRUSH:
To adjust the centre brush. If the machine removes dirt and debris inefficiently or leaves dirt behind, it needs
to be adjust. Lower the centre brush and proceed as follows:
1. Remove the protective case Detail 2 Fig.4
2. Loosen the bolt Detail 1 Fig.10 in the slot at the front
3. Tighten bolt Detail 2 Fig.10 until the three bolts Detail 1, 2 and 3 Fig.10 make
If the brush is too flat on the ground, proceed in reverse:
1. Unscrew the bolt Detail 2 Fig.10 and tighten the bolt Detail 1 Fig.10.
NB: To ensure the centre brush is correctly adjusted, measure its "Track" as follows:
1. After making adjustments, start the machine up and, without moving either forwards or backwards,
leave it standing in the same place for at least 10 / 15 sec. with the centre brush lowered.
2. Turn off the motor, raise the centre brush and move the machine forwards manually until the mark left
by the rotation centre brush on the floor is visible, as shown in Fig. 11
NB: The width of the track must not be under 3 cm:
u FORWARD REGULATION:
If a machine with mechanical forward drive has lost power, regulate the forward drive as
Loosen bolt Detail 1 Fig. 12, move the driving wheel Detail 3 closer to the hub of the driving pulley Detail 4 and
unscrew the threaded adjusting screw Detail 2 Fig.12 as required.
IMPORTANT: After regulation the wheel Detail 3 must be as close as possible to the driving pulley
Detail 4 WITHOUT ACTUALLY TOUCHING IT.

ADJUSTMENTS

pag. 38
contact.
follows::