Bi-Wiring; Bi-Amping - T+A SOLITAIRE S 530 Bedienungsanleitung

Bi-Wiring

Bi-wiring provides better
sound by separating the bass
(Bass) signal and mid-range/
treble signals (Mid/High). Two
speaker cables are required
for each loudspeaker.
If your power amplifier has two
loudspeaker outputs (A and B),
the speakers are connected
as shown in the illustration
below; If the power amplifier
has outputs for only one pair
of loudspeakers, connect both
cables to these outputs in
parallel.
In bi-wiring arrangements the
cables bridging of the woofer
(Bass) and mid/high (Mid/High)
input terminals must be remo-
ved!

Bi-Amping

For bi-amping, the signal paths
of the low and mid/high ranges
are separated before the power
amplifiers.
One stereo power amplifier
takes over the amplification
of the low frequency range for
both channels while the other
stereo power amplifier drives
the mid/high frequency range
of both channels.
In bi-amping arrangements the
cables bridging of the woofer
(Bass) and mid/high (Mid/High)
input terminals must be remo-
ved!
30