AIRROBO T9 Bedienungsanleitung Seite 9

T9 说明书英文版_20210629.pdf 9 2021/6/29 16:39:50
7. Start cleaning
After the robot is powered on, short press key
(press any button to pause during using).
Note:
• The sweeping robot cannot be used to remove liquids.
• If the battery level is less than 20, the machine cannot work. Please charge it.
• The machine will return to the charging base automatically if the battery level is less than 20% in use and will be powered off
and start cleaning automatically after the battery level reaches 80%.
• Please clear various wires (including power line of charging base) on the ground before use so as to avoid outage and damage of
objects or wires when wires are dragged by the host.
8. Installation of mopping module（ Figure3.1f)
（a) Install Electric-controlled water tank;
(b) Fill the water tank: uncap the cover and fill with water;
(c) Intall the module: push the module horizontally along the rear part of the robot.
The module is installed in place if you hear a "click" sound.
C
M
9. Remove the mopping module（ Figure3.1g)
Y
When the robot is finished working, press the button in the
middle of the water tank to remove the mopping module
CM
backwards, empty the water in the water tank and clean
the mopping cloth (do not move or turn the robot over
MY
during cleaning) .
CY
CMY
K
3.2 Operation
1) ON/OFF
Long press
Long press
Note: The machine cannot shut down when the host is being charged.
2) Sweep/Pause
After the machine is started, short press
Note:
• The cleaning robot cannot be used to remove liquids.
• If the battery level is less than 20%, the machine cannot work. Please charge it.
• The machine will return to the charging base automatically if the battery leve is less than 20% in use and will be powered off and start
cleaning automatically after the battery level reaches 80% Please clear various wires (including power line of charging base) on the
ground before use so as to avoid outage and damage of objects or wires when wires are dragged by the robot.
on the robot or use mobile APP to start cleaning.
（ Figure3.1g)
key for 3s, the indicator light is on and the machine is started.
key for 3s when the machine is under standby mode,the indicator light is off and the machine shuts down.
key on the host or start the machine using mobile APP.(Press any key to pause in use)
（ Figure3.1f)
10. Instructions for mopping module
① Please do not use the mopping module when it is left
unused.
② For the sake of safety, please be sure to remove the
mopping module when it is being charged or left unused.
③ Please do not mop the carpet. Set a forbidden area in APP
to prevent the machine from entering the carpet.
④ To achieve a better mopping effect, the mopping module
should be installed after the floor is swept for three times.
⑤ To add water or clean the dust cloth when the machine
works, please pause it, and take out and reassemble the
mopping module according to steps 8 and 9. Please do
not move or turn over the host so as to avoid failing in
positioning and losing the map.
⑥ Mopping function of the machine is intended for wiping
and is conducive to deep cleaning. it cannot remove
stubborn stain effectively and replace labor force.
- 05 -