AIRROBO T9 Bedienungsanleitung Seite 8

T9 说明书英文版_20210629.pdf 8 2021/6/29 16:39:50
Part 3 Installation and operation
3.1 Installation
1. Connect power line and feed the excess wire into the slot.（ Figure3.1a )
2. Place charging base against the wall and connect the power.（ Figure3.1b )
Note:
• Ensure a space of above 0.5m on both sides of the charging base and a space of above 1.5m in the front.
• If the power line is vertical to the ground, it may be dragged by the host and consequently the charging base may be powered off .
• The charging indicator is normally on when powered on and off when charged.
3. Please do not move the charging base arbitrarily and keep it out of direct sunlight.（ Figure3.1c )
Note:
• If the charging base is relocated, the host may fail in positioning and lose the map. When restarted, the host will rebuild and memorize
the map and the rebuilt map may lose cleaning information of forbidden areas and other areas。
• Direct sunlight will interfere with recharging signal and consequently the host may be unable to return to the charging base.
C
M
4. Installation of side brush.（ Figure3.1d )
Y
Make the left side brush (L) and the right side brush (R) correspond to L and R on the bottom casing, press L and R and the side brushes
are installed till you hear a "cracking" sound.
CM
MY
5. Starting up and charging.（ Figure3.1e )
Long press
CY
Note:
CMY
If the machine cannot be started due to low battery, please charge the host on the charging base and the machine will be started
automatically. The machine can work normally only when the battery level is ≥20%.
K
（ Figure3.1c )
6. Connect mobile APP (this step can be skipped)
Please refer to WiFi connection guideline, then connect mobile APP.
Note: If you want to connect to Alexa, please click" Alexa" and follow the prompts！
Tuya Smart
（ Figure3.1a )
to switch on the robot. Charge the robot on charging base when the power indictor light is normally on.
（ Figure3.1b )
（ Figure3.1d )
- 04 -
（ Figure3.1e )