Automatic Mode - AIRROBO T9 Bedienungsanleitung

T9 说明书英文版_20210629.pdf 10 2021/6/29 16:39:51
3) Charging

Automatic mode:

The robot will return to the charging base automatically after work.
Manual mode:
Under suspended state, short press
The indicator light is under breathing mode when the recharging host is charged.
Note: If the robot can not find the charging base, it will automatically return to the starting position. Please manually put the robot back to
the charging base for charging.
4) Cleaning mode（ Figure3.2a)
After the robot is powered on, it will scan and generate the map and divide it into areas intelligently. Then sweep the areas one by one
along the wall orderly, efficiently and thoroughly and plan the cleaning route in a bow/S shape. The robot will return to the charging base
automatically after cleaning.
Note:
Do not move the robot casually and frequently when it is cleaning. After moving, please put the robot near the original position. When it
starts again, it will try to reposition itself. After successful positioning, it would follow the planned path and continue to work. If the
positioning fails, the robot would abort previous mission, make a map and do the cleaning again. Even it maynot find the charging base.
5) Spot cleaning
When a local area needs a deep sweep, the user specifies a point on the map on the APP, the machine will automatically drive to the
vicinity of the point, take the point as the center, and clean within 1.5m x 1.5m.
6) Partial cleaning（ Figure3.2b)
When the robot cannot be controlled by the mobile APP, please remove the robot to the place you want to clean. Long press the
button for 3 seconds, and the robot will clean twice within the scope of 2mx2m centering on itself.
C
M
Y
CM
MY
CY
CMY
K
7） User-defined area cleaning
Use the mobile APP to set the size and location of the area you want to clean. You can set one or more areas. The robot would clean
according to the areas you set.
8） Restricted area
Set one or more forbidden areas using mobile APP. The robot will not sweep forbidden areas but other areas.
Note:
• The robot may intrude into the restricted area due to positioning errors, abnormal sensors and other reasons.
• The permanent closed zone may become invalid due to the big change of the position of the charging seat and furniture. Therefore,
please try not to move or interfere with the robot during cleaning.
• The permanent restricted area would be lost when the map is rebuilt.
9） Schedule cleaning
Schedule cleaning can be set by mobile APP. The robot will start cleaning automatically at the appointed time and return to the charging
base after cleaning.
10） WiFi reset
If the mobile phone cannot be connected to the machine due to modification of router configuration and password or for other reasons,
please press the both keys
purple and flickers slowly.
key to start recharging or when the recharging host is charged under the control of mobile APP,
Area to be cleaned
Area being cleaned
（ Figure3.2a)
simultaneously for 3s till a voice prompt "WiFi has been reset" is given and the indicator light turns
2
（ Figure3.2b)
- 06 -