Herunterladen Inhalt Inhalt Diese Seite drucken

Veripart VPMVR50 Benutzerinformation Seite 56

Vorschau ausblenden Andere Handbücher für VPMVR50:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Interruption of power supply or failure of the system:
• See to frozen foods if the freezer will not be run for an extended time
(such as interruption of power supply or failure of the freezerrating
system).
• Try to open the freezer door as little as possible. In this way food can
remain safe and fresh for hours, even in hot weather.
• If you receive a power outage notice in advance:
1.
Adjust the thermostat knob to the high mode an hour in advance,
so that food is fully frozen (do not store new food during this time!).
Restore the temperature mode to the original setting when the power
supply returns to normal.
2.
You can also make a block of ice using a watertight container and put
it in the upper part of the freezer, so as to extend the storage time of
the food inside.
Note!
• Once the freezer is in use, it is better to use it continuously; and under
normal circumstances. Do not frequently stop or start its use, so as not
to affect the service life.
Defrosting
After a period of use, a thin layer of frost will form on the freezer
compartment's inner wall (or evaporator) surface, which may affect
freezerration if the frost layer exceeds 5mm in thickness. In such cases,
gently scrape the frost off using an ice scraper rather than any sharp, metal
implements. Frost should be scraped off every 3 months or so, but if the
normal use of drawers and normal access to food are affected by frost
build-up, make sure to remove the frost in a timely manner.
56

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis