Software Installation
Cutting the Test File-LaserGRBL
Tip: Please adjust the focus before engraving
Step 1: File → Open File: Open GCODE file or
Image format file, Here use "Letter A.JPG" as the
test file.
Step 2: Select the "Vectorize " as coversion Too,
then Click "next".
Step 3: Set the Speed and Values.
Depending on Materials they will require different speeds
and Values.
Material: 2mm thickness
Speed: 300 mm/min
S-Max: 10000
Step 4: Click the direction button to control the machine
to reach the starting point, click "set zero point" and then
click "run program" to start cutting.
basswood multilayer
board
39