Genmitsu Jinsoku LC-50 Plus Benutzerhandbuch Seite 16

Assembly Guide
STEP 8: Linear Rod Assembly
1. Push the coupling as shown, insert the linear rod into the coupling, and the linear rod will protrude from the
coupling.
Push
Optical Shaft Coupling
2. Insert the linear rod assembly through the
(2) M4*6mm Screws
timing belt as shown, then insert the linear
rod into the bearing hole and push it to the
(2) M4*6mm
5mm
limit position.
Screws
3. Push the coupling as shown, so that the
motor shaft is inserted into the coupling,
and stop pushing when the coupling end
face is 5 mm away from the motor end face.
Bearing hole
Motor shaft
4. Tighten the left end of the coupling with
Push
the M4*6mm screws, and leave the
Optical Shaft
M4*6mm screws on the right end
Coupling
Timing Belt
temporarily.
14