Software Installation
Tip: Please zero the coordinates and adjust the focal length before engraving on the machine.
Step 3: Double click the window "Spd/Pwr", set laser intensity (Svalue) and travel speed.
The max power should be set 10%-100%, depending on materials they will require different speeds and percentage.
Set the power scale to your lowest test power+10% to mimic what you want. Make a record and find that power
speed.
Step 4: Click "Start" to begin to engrave.
For more details you can refer to the document "LightBurnDocs".
Wear the glasses! Do not set them down like this with the laser on.
36