Troubleshooting - Clearaudio TT5 Bedienungsanleitung

User manual / Bedienungsanleitung

6. Troubleshooting

First check the possible causes to rule out incorrect operation if you have a problem with your
tonearm.
Please contact your dealer if the error persists!
Never try to open the unit and/or repair it yourself, this will void the warranty!
Error
Needle bounces or
slides across record
The tonearm
carriage gets stuck
Made in Germany
Cause
Is the record or the stylus dirty or
damaged?
Has the tracking force been set
too high/low?
Is the record deformed or
scratched?
Is the turntable leveled?
Were all settings
correctly during assembly?
Is the glass tube dirty?
Is the tonearm leveled?
Is the turntable leveled?
Clean the record
Clearaudio offers many helpful accessories
for care and cleaning. In the event of damage,
we recommend an assessment by a specialist
and, if necessary, an exchange.
Adjust the tracking force. Use only a suitable
gauge! For example Clearaudio „Weight
Watcher touch" or „Smart Stylus Gauge".
Use a record clamp or replace the record.
Check the alignment of the turntable and
adjust if necessary.
made Check all settings and adjust them again
if necessary.
Use a cotton bud and a commercially available
glass cleaner to clean the glass tube.
Put some glass cleaner on the cotton bud
and slide it through the glass tube with a
movement from the inlet to the outlet groove.
Check the alignment of the tonearm and
adjust if necessary.
Check the alignment of the turntable and
adjust if necessary.
Measure
/ or the cartridge.
Page / Seite 17
TT5