Clearaudio TT5 Bedienungsanleitung Seite 16

User manual / Bedienungsanleitung
If the cartridge is not parallel to the reference line, rotate the tonearm base in the appropriate
direction, fix it in place and recheck your result.
Repeat this process until the stylus exactly follows the reference line of the linear gauge.
Finally, hand-tighten the screw/screws of the tonearm base to fix the final adjustment.
Now, check all settings as described from point 5 on and repeat the adjustment if necessary.
After setting the tangential tracking angle, fix the tonearm pilar in the tonearm base / clamping ring
or TT5 swing base.
Now you can remove the TT5 VTA fix by unscrewing the M4 cylinder head screws with a hex wrench
(# 3).
The Clearaudio TT5
Page / Seite 16
tonearm is now fully adjusted and ready to play.
© clearaudio electronic GmbH, 2022-12