Horizon Hobby AeroScout S 1.1m Float Set Bedienungsanleitung Seite 7

3. Install the water rudder onto the rod, using the included
setscrew (M2 x 3mm).
Ensure the setscrew in the water rudder collar aligns
with the flat on the torque rod.
4. Verify the aircraft rudder and water rudder align. Adjust
as needed before applying adhesive in the following
step.
5. Apply medium viscosity super glue to the slot you cut
in Step 2. When the glue is dry cover the slot using the
Incision Stickers.
Aeroscout S 1.1m Float Set
EN
M2 x 3mm
INCISION
STICKERS
7