Use And Maintenance - BFT MAXIMA ULTRA 36 Installations- Und Gebrauchsanleitung

3.1 GENERAL SAFETY
• The barrier is intended exclusively for vehicle use. Indicate and delimit any walkways using a specifi c sign.
• Keep children, people and objects out of the operating range of the automation, in particular during operation.
• For safety reasons and in compliance with the regulations in force, it is advisable to use the appropriate control
unit.
• The installation must be performed following the prescriptions contained in the attached sheet "GENERAL
INSTRUCTIONS FOR SAFETY".
• Electrical connections must be carried out in compliance with the laws in force.
• The installer must instruct the user about the correct operation of the automatism, the manual emergency
operation, and the possible risks during operation.
• Perform risk assessment taking appropriate measures to eliminate them as prescribed by the machinery directive
2006/42/EEC, installing the safety devices.
• Before performing any task on the equipment, cut off the power supply using a cut-off switch.
• Cleaning and maintenance intended to be performed by the user must not be carried out by children without
supervision
3.2 NOTICES
The good operation of the automation is guaranteed only if the data reported in this manual is respected.
The Company is not liable for damage caused by failure to observe the rules of installation and the direc-
tions given in this manual.
The descriptions and illustrations in this manual are not binding. Leaving unchanged the essential charac-
teristics of the product, the Company reserves the right to make at any time any changes which it considers
useful to improve in technical, construction and commercial terms the product, without committing itself
to update this publication.
3.3 USE
• Strictly follow the directions contained in the attached sheet "GENERAL INSTRUCTIONS FOR SAFETY".
• In the event of manual emergency operation, follow the directions outlined in item 2.8.
• Refer to the use and installation manual of the control unit.
3.4 ROUTINE MAINTENANCE (EVERY SIX MONTHS)
• Maintenance must only be performed by qualifi ed personnel.
• Record the on site servicing tasks in the form at page 38.
Check the condition of the barrier structure.
1
Check the condition of the bar clamping.
2
Check the condition of the spring, of the chain and of its anchors.
3
Check bar balance.
4
Check that at run end the bar is horizontal and/or vertical
5
Check the operation of the control unit and of the safety devices
6
Monitor the manual emergency operation.
7

3. Use and maintenance

- 15 -
EN