STIEBEL ELTRON DHF 13 C Bedienung Und Installation Seite 22

INSTALLATION
Installation
Fitting wall mounting bracket and appliance
3
1 Wall mounting bracket
2 Threaded stud
3 Threaded bush
f Remove the wall mounting bracket.
f Mark out the drill holes with the installation template (in the
centre section of these instructions). If the appliance is to be
installed with surface-mounted water connections, also mark
out a fixing hole in the lower part of the template.
f Drill the holes and secure the wall mounting bracket with
2 screws and 2 rawl plugs. The screws and rawl plugs are
not part of the standard delivery.
f Fit the wall mounting bracket.
f Mount the appliance on the threaded stud.
f Push the back panel firmly against the wall. Secure the back
panel using the threaded bush. You can compensate for a tile
offset with the nut on the threaded stud.
Installation with offset tiles
≤12
2
1
1 Minimum contact area of the appliance
2 Maximum tile offset
f Adjust the wall clearance with the nut on the threaded stud.
Push the back panel firmly against the wall. Secure the back
panel using the threaded stud.
22 | DHF C
Fitting the cable grommet
1
2
1 Cable grommet
f Fit the cable grommet.
19
3 Nm
f Remove the transport protection plugs from the appliance
pipe connections.
f Fit the pipe connections with flat gaskets onto the water
connections.
Making the electrical connection
WARNING Electrocution
Carry out all electrical connection and installation work
in accordance with relevant regulations.
WARNING Electrocution
Connection to the power supply is only permissible in the
form of a permanent connection in conjunction with the
cable grommet. Ensure the appliance can be separated
from the power supply by an isolator that disconnects all
poles with at least 3 mm contact separation.
WARNING Electrocution
Ensure that the appliance is connected to the earth con-
ductor.
Material losses
!
Observe the type plate. The specified rated voltage must
match the power supply.
f Connect the power cable to the mains terminal (see chapter
"Installation / Specification / Wiring diagram").
1
24
5 Nm
www.stiebel-eltron.com