Troubleshooting; Spare Parts List Content; Possible Cause - FMS 2000mm Beaver V2 Bedienungsanleitung

E
N
Trouble shooting
Problem
Aircraft will not respond to
the throttlebut responds to
other controls.
Extra propeller noise or
extra vibration.
Reduced flight time or
aircraft underpowered.
Control surface does not
move, or is slow to respond
to control inputs.
Controls reversed.
-Motor loses power
-Motor power pulses then
motor loses power.
LED on receiver flashes
slowly.

Spare parts list content

FMSPQ101-1
FMSPQ102-1
FMSPQ103-1
FMSPQ104-1
FMSPQ105-1
FMSPQ106
FMSPQ107-1
FMSPQ108
FMSPQ109-1
FMSPQ110-1
FMSPQ111-1
FMSPQ112
FMSPQ113
FMSPQ114-1
FMSPQ115-1
Visit our website: www.fmsmodel.com to see photo of this product. Enter the key word "ESC" in the search bar for the
stock ESC instruction manual.

Possible Cause

-ESC is not armed.
-Throttle channel is reversed.
-Damaged spinner, propeller,
motor or motor mount.
-Loose propeller and spinner parts.
-Propellor installed backwards.
-Flight battery charge is low.
-propeller installed backward.
-Flight battery damaged.
-Control surface, control horn,
linkage or servo damage.
-Wire damaged or connections
loose.
Channels are reversed in the
transmitter.
-Damage to motor, or battery.
-Loss of power to aircraft.
-ESC uses default soft Low Voltage
Cutoff(LVC).
Power loss to receiver.
Fuselage
Main Wing Set
Horizontal Stabilizer
Vertical Stabilizer
Battery Hatch
Antenna Foam Cover
Cowl
Spinner
Engine
Vortex Generator
Airspeed Head Set
Antenna
Servo Cover
Main Landing Gear Set
Wing Strut Set
-Lower throttle stick and throttle trim to lowest settings.
-Reverse throttle channel on transmitter.
-Replace damaged parts.
-Tighten parts for propeller adapter, propeller and spinner.
-Remove and install propeller correctly.
-Completely recharge flight battery.
-Replace flight battery and follow flight battery
instructions.
-Replace or repair damaged parts and adjust controls.
-Do a check of connections for loose wiring.
Do the control direction test and adjust controls for
aircraft and transmitter.
-Do a check of batteries, transmitter, receiver, ESC, motor
and wiring for damage(replace as needed).
-Land aircraft immediately and recharge flight battery.
-Check connection from ESC to receiver.
-Check servos for damage.
-Check linkages for binding.
FMSPQ116 Linkage Rod
FMSPQ117 Screws Set
FMSPQ118 Pipe
FMSPQ119-1 Decal Sheet
FMSFLT002-1 Float Set
FMSFLT003-1 Float Strut Set
FMSPROP035 Propeller
FMSBM029 Motor Board
FMSDJ014 Motor Mount
FMSDZ005 Motor Shaft
FMSKV550 Brushless Motor
PRESC030 60A ESC
FMS17GAP 17g analog gear servo positive
FMSCON003 Multi Connector System
FMSRE015 Retract
16
Solution