Assembly Instructions - Blumfeldt Cosmic Beam Bedienungsanleitung

EN
16

ASSEMBLY INSTRUCTIONS

Preparation
1. Take everything out of the box. Remove the package with the accessories.
Check the accessories in the list for completeness.
2. Have a Phillips screwdriver and a spanner (suitable for the M6 nuts) ready.
3. Read these operating instructions carefully before assembly and use.
Keep the operating instructions in a suitably safe place in case you need to
refer to them in the future.
Assembly
1. The heater must be installed at least 1.90 m above the floor, and the
distance to the sides and to the ceiling must be at least 70 cm.
2. Drill two holes in the ceiling or wall (see drawing). Place two expansion
screws in the holes. Use a spanner to tighten the union nuts clockwise until
they are firmly seated in the holes. Unscrew the nuts and put them aside
with the washers for later use.
3. Place the upper bracket on the ceiling or wall. Pass the holes of the two
expansion screws through the screw threads, place the washers and spring
washers on them and fasten them with the nuts mentioned above (under
step 2).
4. Place the lower brackets on the back of the heater. Fasten with the screws
(M6x8) using an Allen key.
5. Screw the upper brackets (in the wall or ceiling) to the lower brackets
(on the unit). Use the screws (M6x16) for this. For wall mounting, pay
attention to the control unit on the left side of the unit.
6. Loosen the screws (M6x16). Adjust the heater to the desired angle and
tighten the M6x16 screws. The adjustable angle is up to 60°.