ChiQ MRF-440W Benutzerhandbuch Seite 9

Enabling the Smart function
•
Press the Function key to select Smart until the corresponding icon gets flickering, and then press the
OK/Lock key within 5s for confirmation. If the OK/Lock is not pressed within 5s, the setting will be
invalidated.
Exiting the Smart function
•
Under the Smart mode, press the Function key to select Smart until the corresponding gets flickering, and
then press the OK/Lock key for confirmation. The Smart function will get exited.
When the Holiday or Fast Freeze function is enabled, the Smart function will be disabled automatically.
Child Lock
When the Child Lock function is enabled, the temperature and function are subjected to no change to
prevent maloperation.
In case of no key operation within 3 minutes, the Child Lock function will be enabled automatically.
Enabling/exiting the Child Lock function manually
Press and hold down the OK/Lock for 3s, then the Child Lock function can be enabled/disabled.
Door open alarm
If any door is open for more than 3 minutes, buzzer alarms will be continuously issued, which can be
stopped when any key is pressed, but will be restored after 3 minutes if the door keeps open. The alarms
will not be lifted until the door is closed.
Power cut memory
In case of power failure, the refrigerator will maintain the operating state before power failure when power
supply is restored.
Power-on delay
In order to protect the refrigerator compressor from being damaged in the case of short-time power failure
(i.e., less than 5 minutes), the compressor will not be started immediately after it is powered on.
Over-temperature alarm (only after power outage)
When the refrigerator system is powered on, if the freezer sensor temperature is higher than -10℃, digits of
the freezer zone get flickering on the display. The freezer temperature can be displayed when any key is
pressed, and the normal display will be restored when any key is pressed again or after 10s.
Fault alarm
In case E0,E1,E2,EH, or EC is displayed on the operation panel, it indicates fault with the refrigerator. Please
contact the aftersales person for visiting service in such case.
Heater On/Off
After keys are unlocked, hold down the "Temp." key, and then press the "Function" key for more than 3
seconds to enter the anti-sweat heater setting program. When "FL" is displayed, press the "Temp. Zone" key
to display the state of anti-sweat heater. The heater is On by default (with "1" displayed), and you can press
the "Temp." key to switch between "1" (ON) and "0" (OF) at this time.
Instructions for use of the foldable glass shelf (if applicable)
Pull out the lower glass shelf first. Then move the lower shelf in the manner as illustrated on the picture
below. Make sure the shelf isn't placed in a position as illustrated on the right-most picture, so that it will not
come off.
Tips for Water dispenser
The refrigerator includes a water dispenser which makes it easier to fill your cup of water and have access
to cold water almost immediately. The water dispenser includes one tank of 2.5 litres of water which has to
be filled out. To use water dispenser, follow the instructions below:
Filler cover
9