Safety; Intended Use; Materials Used - Conel CLEAR STOP Montage- Und Betriebsanleitung

40
4

SAFETY

4.1

INTENDED USE

Both installation and use of the water leak protection system are subject to the applicable national regula-
tions. Alongside the operating instructions and the legal regulations applicable in the country and place of
use in respect of accident prevention, the recognised technical regulations for safe and professional work
must be observed.
The water being used must comply with the European Drinking Water Directive!
The manufacturer/supplier must be consulted before using water of a different quality or water with addi-
tional additives.
This water leak protection system is suitable for use in cold drinking water up to a maximum water and am-
bient temperature of 30 °C. It is manufactured according to the state of the art and recognised German
safety regulations.
The water leak protection system may only be used as described in the operating instructions. Any other
use or use beyond the specified use is considered to represent incorrect use.
Additional dangers exist in the event of incorrect use and if the danger symbols and safety instructions are
ignored. The manufacturer/supplier shall not be responsible for any resulting damage. All risks are borne
solely by the user.
Intended use includes observance of the operating instructions.
The manufacturer/supplier must be consulted before using the leak protection system outside the limits
of use described in these operating instructions. The water leak protection system must only be used as
intended in a technically fault-free state, while maintaining safety and hazard awareness, and in compli-
ance with the operating instructions.
Ensure that malfunctions are rectified immediately!
If a leak protection system is operated when not installed, there is a risk of crush-
ing due to rotating parts!
4.2

MATERIALS USED

The materials used are resistant to the physical, chemical and corrosive loads expected to be encountered
in drinking water and fulfil the specifications given in the test regulations VP 638 ("Leakage detectors for
installation in drinking water systems"). All materials are hygienically and physiologically harmless. Plastics
contacted by drinking water fulfil the KTW Guideline (Guideline for the Hygienic Assessment of Organic
Materials in Contact with Drinking water) of the German Federal Environmental Agency (UBA) and
DVGW (German Technical and Scientific Association for Gas and Water) working sheet W 270. Metallic
materials fulfil the requirements of DIN 50930-6 (Effect of metallic materials on the quality of drinking wa-
ter).