Samoa 560 230 Bedienungsanleitung Seite 30

All manuals and user guides at all-guides.com
Dispensing in normal mode
Normal mode is the standard dispensing. While
the count is made, the partial and resettable
total are displayed at the same time (reset total).
WARNING
S
HOULD ONE OF THE KEYS BE ACCIDENTALLY PRESSED
DURING DISPENSING
A few seconds after dispensing has ended, on the
lower register, the display switches from
resettable total to general total: the word reset
above the word total disappears, and the reset
total is replaced by the general total.
This situation is called standby and remains
stable until the user operates the meter again.
Partial reset (normal mode)
The partial register can be reset by pressing the
reset key when the meter is in standby, meaning
when the display screen shows the word
"TOTAL".
After pressing the reset key, during reset, the
display screen first of all shows all the lit-up digits
and then all the digits that are not lit up.
836 828 R. 01/16
4
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
Operating mode
,
THIS WILL HAVE NO EFFECT
Daily use
At the end of the process, a display page is first
of all shown with the reset partial and the reset
total and, after a few moments, the reset total is
replaced by the non resettable Total.
Resetting the reset total
The reset total resetting operation can only be
performed after resetting the partial register. The
reset total can in fact be reset by pressing the
reset key at length while the display screen shows
reset total as on the following display:
Schematically, the steps to be taken are:
1. Wait for the display to show normal standby
display page (with total only displayed)
2. Press the reset key quickly.
3. The meter starts to reset the partial.
4. While the display page showing the reset
total is displayed.
Press the reset key again for at least 1
second.