Herunterladen Inhalt Inhalt Diese Seite drucken

Product Details; External Features - EcoFlow Smart-Home-Modul Installationshandbuch

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 25
EN

3. Product Details

3.1 External Features

1. Load Circuit Control Board
The SHP can be set up to control a total of 10 load circuits, circuits 1, 3, 5, 7, 9 on the left and 2, 4, 6, 8,
10 on the right. There is a button allowing users to manually reset each circuit relay if there has been
an overcurrent event on the circuit. An indicator lamp on the button turns red if there is a fault in that
circuit.
A lightning bolt indicator for each load circuit is illuminated if that load circuit is energized through one
of the sources (grid or power station).
2. Grid Indicator and Infinity Port Indicator
There are three energization indicators on the SHP, one for the grid, two for the DELTA Pros. If any of
these indicators are illuminated, SHP is energized from that source and, therefore, cannot be opened to
be serviced.
3. Infinity Port and Enable Button
There are two infinity ports on the SHP, which can be either on the bottom of the SHP (default),
or relocated to the front. They connect DELTA Pros to the SHP through the Infinity Cable (one for
each DELTA Pro). Once plugged in, SHP and DELTA Pro will try to establish connection through
communication and SHP's control circuitry may be powered via DC current from the DELTA pro. Press
the enable button located near the infinity port (labeled "AC 1" or "AC2" to make DELTA Pro ready for
output.
4. Panel Open Alarm System
When the DELTA Pro load circuits are energized, an alarm will sound if the front panel cover is opened.
To de-energize the product, all upstream breakers must be opened and both DELTA Pros must be
unplugged.
3
1
2
3
4
5
6
7

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis