Cleaning And Care - Klarstein VINSIDER 36 Bedienungsanleitung

EN
38

CLEANING AND CARE

Defrosting and condensation
Defrosting of your wine cabinet is fully automatic. It requires no action on your
part.
During operation, you may notice condensation drops forming on the rear inside
wall of the cabinet. They will be eliminated during automatic defrosting.
Cleaning
Before any cleaning, unplug the device from the mains.
Never use abrasives or a scraper sponge when cleaning the inside or the outside
of your wine cabinet.
• Remove all accessories (racks, etc.). Wash them using lukewarm water to
which has been added a gentle unscented detergent (dishwashing liquid for
example); rinse with bleach water and carefully dry off.
• Wash the inside walls in the same way; pay particular attention to the rack
supports
• Wash the door seal as well as under the seal.
• Plug the wine cabinet into the mains.
From time to time, dust off the condenser behind the device; accumulated dust
may reduce the efficiency of your wine cabinet.
In the event of a prolonged absence, empty and clean out the device; maintain the
door slightly open during the period of non-use.
Replacing the illuminating lamp
The device uses light emitting diodes (LEDs). This type of diode cannot be changed
by the user. The life cycle of the LEDs is long enough so that they do not need to
be changed.
If however, in spite of the care taken by the manufacturer, the LEDs do fail, please
contact your Customer Care Service for any repair.