Troubleshooting - Klarstein VINSIDER 36 Bedienungsanleitung

TROUBLESHOOTING

Problem
The appliance makes
lots of noise.
Liquid flowing sound
inside the cabinet.
The appliance does
not start.
Compressor runs
continuously.
Door does not seal
tightly?
The appliance does
not cool sufficiently.
Unpleasant smells
inside cabinet
Condensate on the
glass door.
The light is not
working.
Solution
Please adjust the front foot, keep the appliance leveling.
Please keep the appliance a bit space from walls.
It is normal because of the refrigerant working inside.
Make sure the appliance is connected to the power
properly.
Make sure switch on the power.
The compressor re-starts after 5 minutes for a power
cut.
If no cold is being produced, call theafter-sale service.
After long time use, the door seal might get stiff &
distorted partially.
1. Heat the door seal with hot-wind blower or hot towel.
2. The door seal get softened and close the door
Please adjust temperature setting.
Keep the appliance away from sunlight or heat.
Please do not open the door frequently if no need.
A little bit plastic smell for newly-buy appliance is
normal and will disappear after a short time.
Clean the compartment and ventilate it for a few hours.
Please do not open the door frequently or for a long
time.
Please do not set the temperature too low.
High ambient temperature and humidity would cause
condensate.
Check the power supply first.
Call the retailer's after-sale service if the light is broken.
EN
39