Installation - Klarstein VINSIDER 36 Bedienungsanleitung

EN
30

INSTALLATION

Before first Use
Allow 24 hours before switching on the wine cellar. During this time we
recommend that you leave the door open to clear any residual odors.
Note: All models without front venting (air opening) are strictly for free standing
only.
Location
The location you have selected for your wine cellar should:
• be unencumbered and well ventilated;
• be well away from any heat source and direct sunlight;
• not be too damp (laundry, pantry, bathroom etc.);
• have a flat floor;
• have a standard and reliable electricity supply
• have a surge protector fitted to the electrical outlet;
• Away from the microwave oven. Certain microwave ovens do not have wave
interference shield. When placed within 1 meter vicinity of the wine cabinet,
they may affect the operation of the wine cabinet.
Placing in cold or hot temperature conditions may cause cellar's temperatures
fluctuating, and it will not reach the ideal one.
Installation
• Unpack and remove all of the protection and adhesive strips from the packaging
around and inside the wine cellar.
• The wine cellar must be positioned such that the plug is accessible. Release
the power cord. Move your wine cellar to its final location. The wine cellar
should be installed in a suitable place where the compressor will not be
subject to physical contact.
• Wine cellar must be leveled before loading your wines. Your wine cellar
is equipped with 4 adjustable feet to facilitate easy leveling. The cooler
recommends that you tighten the back feet to the maximum and adjust the
front feet to level the wine cellar.