Longitudinal Turning; Plain Turning And Recessing; Fixing The Lathe Slide; Turning Between Tips - HOLZMANN-MASCHINEN ED300ECO Betriebsanleitung

18.9.2

Longitudinal turning

18.9.3

Plain turning and recessing

18.9.4

Fixing the lathe slide

18.9.5

Turning between tips

18.9.6

Turning short taper with the top slide

HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
During facing, the planer tool is moved parallel to the axis of
rotation. The feed is carried out either manually by turning
the handwheel on the lathe slide or on the upper slide or by
switching on the automatic feed. The infeed for the cutting
depth is effected via the cross slide.
When facing, the turning tool is moved at right angles to
the axis of rotation. The feed is done manually with the
handwheel of the facing slide. The feed of the cutting depth
is effected by the top slide or the bed slide.
The cutting force occurring during facing, grooving or
cutting-off operations can cause the lathe slide to move.
Therefore fasten lathe slide with the fixing screw.
Workpieces that require a high concentricity are
machined between the tips. A centre hole is drilled
in both face turned faces of the workpiece. The
turning heart is clamped onto the workpiece. The
driving pin, which is screwed into the chuck flange,
transmits the torque to the rotary heart. The fixed
centering point is located in the centre hole of the
workpiece on the spindle head side. The rotating
center point is located in the centering hole of the
workpiece on the tailstock side.
The short taper is turned by hand with the top slide. The upper
slide is swivelled according to the desired angle. The infeed takes
place with the cross slide:
OPERATION
54
ED300ECO