Electrical Connection; Operation; Before Start-Up - HOLZMANN-MASCHINEN ED300ECO Betriebsanleitung

Lubrication pints
17.3

Electrical connection

Dangerous electrical voltage! Connection of the machine as well as electrical
inspections, maintenance and repair may only be carried out by qualified personnel or
under the supervision and supervision of a qualified electrician!
1. Check that the neutral connection and protective earthing are functioning properly
2. Check that the supply voltage and current frequency correspond to the specifications of
the machine
A deviation from the value of the supply voltage of ± 5% is permissible.
A short-circuit fuse must be provided in the power supply system of the machine!
3. Find the required cross-section of the supply cable (it is recommended to use a cable type
H07RN (WDE0282), taking measures to protect against mechanical damage) in a current
capacity data sheet.
4. Make sure that the power source is protected by a residual current circuit breaker.
5. Connect the unit only to a properly grounded outlet.
6. When using an extension cable, make sure that it is dimensioned appropriately for the
connected load of the machine (the connected load can be found in the technical data).
You can find the correlation between cable cross-section and cable length in specialist
literature or consult an electrician.

18 OPERATION

18.1

Before start-up

Oil all bare machine parts with an acid-free lubricating oil.
•
• Check the function of the moving and fixed parts.
• Lubricate the lathe according to the lubrication schedule.
• Check all spindles for smooth running.
• Check that the fixing screws of the lathe chuck are tight.
Clamp a workpiece in the lathe chuck or turn the chuck jaws completely together before
•
switching on the lathe.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
WARNING
NOTE
Deviation of the supply voltage and current frequency
Other lubrication points
Lubrication points can be found on the drive
shaft, on the lead screw, on the slides, on the
handwheels and on the tailstock. Lubricate
these points regularly with a grease gun. See
Maintenance.
OPERATION
46
ED300ECO