Before Use; Charging The Battery Pack (See Fig . A); Attaching/Disconnecting The Battery Pack To/From The Appliance; Checking The Battery Charge Level - Parkside Performance PKHAP 20-Li A1 Originalbetriebsanleitung

WARNING!
■ To avoid potential risks, damaged mains
cables should be replaced by the manufac­
turer, their customer service department or
a similarly qualified person .

Before use

Charging the battery pack
(see fig . A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack 5 from or connect
it to the charger .
■ Never charge the battery pack 5 when the
ambient temperature is below 10°C or above
40°C .
♦ Connect the battery pack 5 to the high­speed
battery charger t (see fig . A) .
♦ Insert the power plug into the socket . The
control LED z lights up red to indicate that the
appliance is charging .
♦ The green LED u indicates that the charging
process is complete and the battery pack 5 is
ready .
♦ Push the battery pack 5 into the appliance .
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack
♦ Push the rotation direction switch 3 into the
middle position (lock) .
Allow the battery pack 5 to click into the
handle .
Removing the battery pack
♦ Press the release button 4 and remove the
battery pack 5 .
PKHAP 20-Li A1

Checking the battery charge level

♦ Press the battery charge level button 6 to
check the charge level of the battery .
The status/remaining charge will be shown on
the battery display LED 7 as follows:
RED/ORANGE/GREEN = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery

Use

Additional handle

NOTE
► For safety reasons, you should never use this
appliance without the additional handle 0
attached .
♦ Remove the additional handle 0 by turning it
in a clockwise direction (see fold­out page) .
♦ Turn the additional handle 0 to the desired
position .
♦ Fix the additional handle 0 in the new position
by turning it anticlockwise .

Depth stop

♦ Undo the screw on the depth stop e .
♦ Insert the depth stop r into the additional
handle 0 .
♦ Ensure that the toothing on the depth stop r
is facing downwards .
♦ Pull the depth stop r out until the distance
between the tip of the drill and the tip of the
depth stop corresponds with the required
drilling depth .
♦ Tighten the screw on the depth stop e to
lock the depth stop r into place .
GB │ MT │ 49 ■