Setting The Co Emissions - VOLTCRAFT SEM5000 Bedienungsanleitung

Use the button
value.
Ensure that the limit for the LOW STANDBY POWER LEVEL
is lower than the one for the STANDBY POWER LEVEL.
When the display is not flashing, briefly press the
to skip to the next setting or briefly press the
leave the setup menu.
9.7 Setting the CO
This menu enables you to set CO
plicable electricity tariff (for example, 0.480 kg/kWh) can be found
on the website of your electricity provider.
If your electricity tariff applies to 100% electricity from sustainable
resources, it is not reasonable to enter 0.000 kg CO
You can input a CO
The energy logger then shows the CO
electricity from sustainable resources.
or to modify the respective flashing
SET: Press to enter
: Edit values
emissions
2
emissions value for a regular electricity tariff.
2
emissions per kWh. The ap-
2
savings achieved by using
2
button
button to
/kWh.
2
77