Technical Information - Nordpeis Q-34UL Montageanleitung

if the chimney does not have the right dimensions or
controlled by gas temperature, outside temperature, air
chimney. The diameter of the chimney should never
table
The active length of the chimney over the hearth
increases
Good air supply to the combustion
in case the chimney is too large relative to the insert,
evaluation of possible measures. Draught that is too
sytem.
A set for fresh air supply is available as an accessory.
recommend the product is designed and prepared
for direct supply of outside air. In older houses also,
the use of fresh air supply set is also recommended.
in the same room or space as the appliance
For your own safety, fully comply with the assembly
instructions. All safety distances are minimum distances.
Installation of the insert must comply with the current rules
and regulations of the country where the product is installed.
Nordpeis AS is not responsible for wrongly assembled
inserts.
Subject to errors and changes.
For the latest updated version go to www.nordpeis.com.
18

2. Technical information

Inserts from Nordpeis all have secondary combustion
and are clean burning. The combustion takes place
gases from the fumes are lit by the heated air. This
soot particles and un-burnt gases (such as CO) and
are thus better for the environment. Clean burning
moisture content of 20%.
Insert
Material
Surface treatment
Flue outlet
cm²
cm²
2
Fuel recommended:
Operation
wood is inserted when the previous load has burned down to ember
GB
Steel
Heat resistant varnish
160
Air vent control
Clean burning
30
50
Top
Outer 150
334
7,3
>12
600
600
750
8,0
80
0,08
278
12
Wood
50
1,8
43
50
Intermittent*