Installation - Klarstein KINGSVILLE 4.1 Bedienungsanleitung

EN
46

INSTALLATION

Preparation
• To operate this gas grill you need a gas bottle (liquid gas) and a suitable gas
pressure regulator. Regulators should comply with standard EN 16129 (as
amended) and national regulations.
• Connect the hose and regulator to the gas bottle on the left side of the gas
grill, making sure the gas bottle is kept away from heat and in a secure
position.
The hose should have a diameter of 8-10 mm. The recommended length of the
hose is a maximum of 1.5 m. The flexible hose should conform to the relevant
standard and local regulations.
Installation
After purchasing a suitable gas bottle, you can set it up with your gas grill.
• Check all parts and make sure no part is missing. If parts are missing, contact
customer service.
• You will need a suitable screwdriver and spanner for assembly. Only use tools
that are intact and suitable for the task at hand.
• Choose a suitable place to set up the device. Place the device on a flat,
sufficiently large surface where it is stable. Make sure the inlet and outlet
regulators are correct and suitable for the gas cylinder valve and the device.
• If the regulator is used outdoors, make sure it is protected from the elements.
• You will need a suitable spanner to connect the gas bottle.
• When connecting the hose, make sure it is not twisted.
Connecting and changing the gas cylinder
• Carry out the changing of the gas cylinder away from any source of ignition.
Position the gas bottle on the left side of your gas grill, it should not be placed
inside the grill. Note that the gas cylinder must be protected from heat and
kept in a safe position.
• When your gas grill is ready to use, insert the regulator into the gas cylinder
valve and tighten securely.