Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
IMPORTANT! Any installation operation shall be carried out by a suitably trained
staff, following carefully the information given in this manual.
Check the packaging at the reception of the goods and store only at a dry place.
Verify that the device has not been damaged during transport or storage opera-
tions. Make sure you receive all the components. Ask the manufacturer for any
possible missing component.
The hose reel has to be wall mounted at a minimum height from the floor
of 2.50 m in order to prevent accidents during work operations. Conside-
ring the hose reel weight and dimensions, its movement requires the use of
lifter devices.In particular cases it is possible to mount it on the floor or on other
machines as accessory, only if complete with a fixed support. The hose-guide
arms can be fixed in three different positions according to the hose reel installa-
tion (see pictures A-B-C). Mount the hose reel in fixed position or with revolving
stand (optional) on stiff and consistent walls using 4 dowels of 10 mm diameter.
WARNING! The manufacturer declines any responsibility for injuries to pe-
ople or damages to things caused by a wrong assembly of the hose reel.
WARNING: Risk of explosion!
Do not lubricate the swivel joints and the seals for Oxigen and Acetylene with oil and
grease. Use lubricant (BAM) approved only.
OSVM
Connect the hose reel to the line by the clamps in dotation, respecting the colours: RED FOR
GAS and LIGHT BLUE FOR OXIGEN.
Fit some safety valves IN CONFORMITY WITH THE "EN 730" RULE on the piping network, before the
connection to the swivel joints and to the end of the hose (on the blowpipe), to prevent a back-fire and a
back-gas. According to the rules, put a ball-tap on the feeding line of the hose reel in order to make the
maintenance operations easier and as a safety valve for dangerous situations.
8 - INSTALLATION
OSV
9 - LINK
- 11 -
A
B
C
Optional
Optional
Werbung
Inhaltsverzeichnis
