Marking And Identification; Installation; Maintenance - Faicom MNP Gebrauchsanweisung

6 - MARKING AND IDENTIFICATION

TORINO RENATO
BUSCA (CUNEO) ITALY
MNP200812
20 bar, 8x12, 12 m
HOSE REEL for AIR
model duty
serial number
IMPORTANT! Any installation operation shall be carried out by a suitably
trained staff, following carefully the information given in this manual.
Check the packaging at the reception of the goods and store only at a dry place. Verify that
the device has not been damaged during transport or storage operations. Make sure you
receive all the components. Ask the manufacturer for any possible missing component.
The hose reel has to be wall mounted at a minimum height of the floor of 2.50 m in
order to prevent accidents during work operations.
In particular cases it is possible to mount it on the floor or on other machines as accessory,
only if complete with a fixed support if in a protected position.
Mount the hose reel already complete with hose on stiff and consistent walls, using 2 dowels
of 8 mm diameter. Connect the hose reel to the line with the included flexible hose. Put an
air valve on the feed line of the hose reel for ease of maintenance.The air valve can be used
as a safety valve in the event of an accident.
WARNING! The manufacturer declines any responsibility for injuries to people or da-
mages to things caused by a wrong assembly of the hose reel.
IMPORTANT! For models suitable for potable water carry out an adequate flow of wa-
shing of parts in contact with the fluid before use.
IMPORTANT! Maintenance should only be carried out by suitably trained staff,
who are familiar with the instructions and information in this manual.
Periodically check the reel for the leaks and smooth operation. Check that there is no fluid
leakage from the fittings and that the swivel joint and fittings are tight.
Periodically lubricate the hose for easy rewinding. If necessary, lubricate the joint.
Make sure that there is no tension in the spring before starting any operations inside
the hose reel. Always close the feeding of fluid to the machine before performing any
maintenance or servicing.
Replace the flexible hose if it shows any signs of wear or damage.
Replace the seal inside the revolving joint if it is worn or damaged.
The replacement of the spring must only be carried out by trained staff, according to the
instructions supplied by the manufacture.
Any replacement of hose reel parts has to be done using original spare parts.
We advise you to contact the manufacturer for any possible anomaly and before replacing
any part.
We affix the CE marking as the manufacturer of this
equipment.
On the equipment is securely attached a tag with curing
5 kg 1059
adhesive system on which are indicated in addition to
the name of the manufacturer and the symbol "CE", all
information necessary for good identification of the ma-
chine (model, duty, serial number, weight, etc.).
weight

7 - INSTALLATION

8 - MAINTENANCE

- 8 -