Replacement Of The Spring - Faicom OSV Gebrauchsanweisung

12 - REPLACEMENT OF THE SPRING

The spring which allows to rewind the hose is placed inside a proper housing centre which
is joint to the drum.
WARNING! The disassembly of the
spring is only permitted to the staff
authorized and suitably trained by the
manufacturer.
Handle with the greatest
care the spring; serious
accidents might occur.
12.1) Make sure that the rewinding sy-
stem is totally unloaded and that the
drum is free.
12.2) Loosen the swivel joints.
12.3) Loosen the screws of the spring lin-
kage shaft.
12.4) Disassemble the opening on the
spring side by a 10 mm wrench and
take out the drum.
12.5) Take out the shaft from the spring
housing.
12.6) Lift the tangs on the drum by a
screwdriver and rotate the spring
housing centre in order to release it
from the drum.
12.7) Turn upside down the drum and
take out the spring housing centre
paying the greatest care so that the
spring does not go out of it.
12.8) Insert and hook the shaft into the
new spring housing centre.
Lubricate the spring and the shaft.
12.9) Put the drum straight and place the
new spring housing centre with the
utmost care.Block the tangs.
12.10) Assemble all the parts and go on as
indicated at point 7.2 of the chapter
"Mounting of the hose".
12.4
12.6
12.7
- 13 -
12.2
12.5
12.7
12.9